Flexlink X45 Manual do Utilizador descarregar pdf (Página 9)

Connect

5113270

5.3 Scan for units

After the appropriate cables are in place we need to identify active units on

the network. This is done by the command “Scan for units” and can be

reached from the Tools-menu or direct with the function button F12. If the

A bus is used every motor has one function controller showing on the dis

play. If the B-bus is used only the function controller of the connected is

showing. On the other hand the drive controller of this motor is also dis

played. These node status are displayed regardless of which menu is cho-

sen later on.

Figure 2 Picture: Scan for units

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sem comentários

Flexlink X45 Manual do Utilizador Página 9